UniFi UF1050

Specification

Radio

  • Fully integrated VCO
  • Fully integrated direct conversion receiver
  • Baseband for 2.4GHz
  • Fast AGC and wide dynamic range allow excellent robustness against fading
  • No production trims or adjustments required
  • Support for common cellular reference frequencies
  • On-chip crystal driver

Transmitter

  • No external PA required for short range cellular handset applications
  • Supports external PA for enhanced range
  • Low output spurii in cellular bands
  • Supports power compensation for stable transmit power across temperature

Receiver

  • Good receiver sensitivity
  • Supports an external LNA for enhanced sensitivity
  • High cellular blocking for good coexistence with cellular radios

Synthesiser

  • Fully integrated synthesizer; no external VCO varactor diode, resonator or loop filter

Processor subsystem

  • Dual 60MHz RISC processors
  • Independent dedicated on-chip instruction and data RAMs per CPU
  • Separate timers, interrupt controller and watchdog for each CPU

MAC accelerator

  • Supports BSS and IBSS
  • Control of radio TX power on per-packet basis
  • EDCA (802.11e QoS packet scheduling)

Auxiliary features

  • Two 8-bit DACs

CCK modem

  • Supports 1, 2, 5.5 and 11Mb/s modes

OFDM modem

  • Supports 6, 9, 12, 18, 24, 36, 48, 54Mbps
  • Options for partial clocking for power saving
  • Dynamic power saving

Physical interfaces

  • SDIO interface (incorporating SPI bus mode)
  • Unity coexistence interface

Encryption

  • Hardware support for WEP40/64, WEP104/128, AES and TKIP

Package options

  • 88-ball WLCSP 5.8mm x 6.4mm x 0.7mm
  • 0.5mm pitch, Pb-free